![]() ![]() When a failure to one member occurs, you will be notified by the RAID BIOS during boot. Although JBOD doesn’t offer other RAID functionality, it makes the hard disks appear to be a single one by combining the drives into one larger logical one without any capacity loss. This RAID array allows you to use one or two hard drives to a JBOD(Just a Bunch Of Disks) array. Selecting Offline Copy builds the mirror before exiting the RAID Note: Selcting Online Copy builds the mirror while in Windows. Select Create with data copy, then press Enter. Select Manual configuration, then press Enter. When asked Are you sure to exit(Y/N)?, press Y to exit and reboot.Īt the next screen select RAID1 then press Enter. When asked Are You Sure(Y/N)?, press Y to accept. Select chunk size from 8k, 16k, 32k, 64k or 128k, then press Enter. Select Manual configuration then press Enter. When asked Are you sure to exit (Y/N)?, press Y to exit and reboot.Ĭontinue with FDISK and FORMAT steps as if you were installing a conventional hard drive. When asked Are You Sure (Y/N)?, press Y to accept. Select Auto configuration, then press Enter. The default chunk size is 64k when selecting Auto configuration.Īs the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS.Īt the next screen select Create RAID Set, then press Enter. For applications that require custom chunk size, Manual Configuration is offered. Striping will destroy existing data on the hard drive. This RAID array to be used on New/Blank hard drives. RAID Arrays are setup in the Vantec 2-Port SATA II 300 PCIe Host Card w/RAID’s BIOS. However, it’s possible to combine hard drives of different sizes and makes. It is recommended to use identical drives for all RAID configurations. The Vantec 2-Port SATA II 300 PCIe Host Card w/RAID is two channel Serial ATA controller that supports two Serial ATA hard disk drives. In most cases, you just need to power up the device and connect them to the ports. Serial ATA hard drives should come with their own accessories. Replace the slot bracket’s holding screw to secure the card. Push the board down firmly, but gently, until it is well seated. To install the card, carefully align the card’s bus connector with the selected PCI Express slot on the motherboard. ![]() Remove the slot bracket from an available PCI Express slot. Unplug the power cord from the back of the computer. Turn off the power to your computer and any other connected peripheral devices. Vantec 2-Port SATA II 300 PCIe Host Card w/RAID x 1 PCI Express-enabled system with one available PCI Express slot Supports Serial ATA II Port-Multiplier specification Supports RAID 0(striping) and RAID 1(mirroring) for speed and data protection respectively Supports Native Command Queuing (NCQ), Non-zero offsets NCQ, and Out-of-order data delivery NCQ Installs in any available PCI Express slot and supports data transfer rates up to 3.0Gbps All brand names and trademarks are properties of their respective owners.Ĭompliant with PCI Express Base Specification 1.0aĬompliant with Serial ATA 1.0 specification with support for full complement of SATA II optional features
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |